Publication

Semiconductor & Quantum Packaging Laboratory

Journal

2009 Fabrication and electrical characterization of Through-Si-Via interconnect for 3D packaging

페이지 정보

작성자 최고관리자 작성일 25-09-15 16:13

본문

Author
Jong-Woong Kim and Seung-Boo Jung
Journal
Journal of Micro/Nanolithography
Vol
8
Page
013040
Year
2009
IF
1.355
Fabrication process of through-Si-via (TSV) interconnects and their electrical characterization method were investigated for 3-D stacked packaging. A prototype, three-layer module with a flip-chip bonding process with anisotropic conductive film (ACF) was fabricated with the process. To measure a single interconnect resistance, a Kelvin structure was designed and applied on the chip and substrate. A theoretical model to calculate the connection resistance of the 3-D TSV interconnects was also derived and used to verify the experimentally measured resistance by applying the Kelvin structure designed. Optimum conditions for the formation of through-holes with the deep reactive ion-etching process were a coil power of 200 W, cycle time of 6.5/5 s, and SF6:C4F8 gas flow rate of 260:100 sccm. Pulse-reverse current provided the finest grain growth during the Cu electroplating and thus prevented the trapping of voids. The experimentally measured resistance was successfully verified by the theoretical model, and the model shows that the resistance value was mainly contributed by the ACF interconnect, not by TSVs.