Publication

Semiconductor & Quantum Packaging Laboratory

Journal

2008 Effect of reflow numbers on the interfacial reaction and shear strength of flip chip solder joints

페이지 정보

작성자 최고관리자 작성일 25-09-15 16:05

본문

Author
Dae-Gon Kim, Jong-Woong Kim, Sang-Su Ha, Bo-In Noh, Ja-Myeong Koo, Dong-Woon Park, Myung-Wan Ko and Seung-Boo Jung
Journal
Journal of Alloys and Compounds
Vol
458
Page
253-260
Year
2008
IF
3.014
The effects of multiple reflows on the microstructural variation and joint strength of the flip chip solder joints were investigated. Conventional Sn–37Pb and a representative Pb-free Sn–3.0Ag–0.5Cu were used, and a popular low cost under bump metallurgy (UBM) of immersion Au/electroless Ni–P plating was employed. In case of Sn–37Pb, only Ni3Sn4 intermetallic compound layer was formed during multiple reflows. In case of Sn–3.0Ag–0.5Cu, (Cu,Ni)6Sn5 intermetallic compound layer was observed after a single reflow, while (Ni,Cu)3Sn4 layer was additionally settled at the interface between the (Cu,Ni)6Sn5 layer and Ni–P UBM. The thicknesses of the intermetallic compound layers increased and coarsened. The shear force of the both joints slightly decreased during the multiple reflows. The decrease of the joint strength was caused by different softening phenomena between the two cases, and that is discussed in the main text.