2011 Effect of Sintering Temperature on Electrical Characteristics of Screen-Printed Ag Nanopaste on FR4 Substrate
페이지 정보
작성자 최고관리자 작성일 25-09-15 16:40본문
- Journal
- Journal of Nanoscience and Nanotechnology
- Vol
- 11
- Page
- 5915
- Year
- 2011
- IF
- 1.338
We investigated the feasibility of a printing technology for Ag circuit formation on a FR4 substrate. A conductive paste containing Ag nanoparticles (73 wt%) of 20–50 nm diameter was screen printed on an FR4 substrate and sintered under a sintering temperature ranging from 100 °C to 200 °C for 30 min. We carried out the thermal analysis of the Ag nanopaste to confirm the suitability of the set-up conditions. To investigate the sintering degree with various temperatures, fractured cross-sections were observed by field emission scanning electron microscopy (FESEM). For electrical characterization of the printed Ag circuit, a four-point probe method was used to measure the direct current (DC) resistivity, while a network analyzer and Cascade's probe system in the frequency range from 10 MHz to 20 GHz were used to measure the scattering parameters (S-parameter) of the sintered Ag conducting patterns. The resistivity under the application of a DC signal decreased as the temperature increased. The measured S-parameters indicated that the electrical losses decreased as the sintering temperature increased due to the interparticle neck formation after heat treatment at high temperatures.