Publication

Semiconductor & Quantum Packaging Laboratory

Journal

2007 Design of solder joint structure for flip chip package with an optimized shear test method

페이지 정보

작성자 최고관리자 작성일 25-09-15 15:57

본문

Author
Jong-Woong Kim and Seung-Boo Jung
Journal
Journal of Electronic Materials
Vol
36
Page
690
Year
2007
IF
1.491

The structure of flip chip solder bumps was optimized in terms of shear height and shear speed using a shear test method with both experimental investigation and nonlinear, three-dimensional, finite element analysis being conducted. A representative, Pb-free solder composition, Sn-3.0Ag-0.5Cu, was used to optimize the shear test of the flip chip solder joints. Increasing the shear height, at a fixed shear speed, decreased the shear force, as did decreasing the shear speed, at a fixed shear height. These experimental and computational results supported the recommendation of low shear height and low shear speed condition for the shear testing of flip chip solder bumps. This optimized shear test method was applied to investigate the effect of various heights of mini bumps on the shear force of the solder joints. The shear force increased with increasing Ni-P mini bump height.